Bitfenix Colossus Micro-ATX Bedienungsanleitung

Quick Installation Guide

a. b.Remove thumbscrew Remove PSU bracketc. d.Secure PSU with screws (Standardscrew 6-32 hex)Secure with thumbscrew PSU Installaon09

a.c.b. Use A or B depending on deviced. Secure with screws (Thumbscrews M3)A BInstall device using M3*5mm RoundscrewsSlide tray into placeInstalling 5

Magnec heat shield(Use when HDDs are installed on the boom)Magnec heat shield11

Ver 1.0 : 2013/10Bitfenix Co., Ltd.3F, No.79, Sec. 1, Xintai 5th Rd., Xi Zhi District, New Taipei City, Taiwan, R.O.C.For the most updated information

Box Contents* Contents and specificaons subject to change without noce.•Colossus Micro-ATX Case•Colossus Micro-ATX Quick Installaon Guideo Screws:T

Removing side panelsa. Remove side panelsb.Remove thumbscrewsBasic InstallaonabFront Top Back Side02

Installing 3.5" drivesa. Remove hard disk tray c. Secure hard disk tray with screws b. Install drives using 6*6mm Round screwsa. Put drives in

b. Install drives c. Secure with screws(M3*5mm Round screws) a. Remove hard disk tray by removingscrews d. Install tray into place Installing 2.5

D. Reset buonB. Headphone jackC. Microphone jackA. SuperSpeed USB3.0 portsE. Power buonDEABC05

a. b.Remove top filter Install fansc. Secure with screwsTop Fan Installaon (120mm)d. Replace top filter06

Boom Fan Installaon (120mm)Boom Fan Installaon (230mm)b. Secure with screws (Remove heat shield if installed)b. Secure with screws (Remove

a. b.Install fan Secure with screwsRear Fan Installaon08